So, now that I have decided to replace my Sunhokey 3D printer, what are my new 3D printer options? And, with so many choices, what are my selection criteria? Read more
Category: Tools
Replacing My Sunhokey Prusa i3 Printer
As I consider replacing my Sunhokey 3D printer, I am looking back at where I have spent my time and how money much I have spent on this neat machine. Read more
3D Printing Easier Than Ever – Ask Rupert
Is 3D printing easier than ever? Yes, you bet it is. Check out Rupert’s story. Read more
3D Printed Circuit Board Holder
A 3D printed circuit board holder is a neat little project and very useful in your electronics workshop. Cheap and cheerful, too. Read more
Impedance Matching Test Jig 3D Printed
Another great ham radio use for a 3D printer is making an impedance matching test jig. Cheap and cheerful. Read more
Shielded Plastic Box for Antenna Switch and More
You can easily build a shielded plastic box with your 3D printer. Just use some aluminum or copper foil tape to create a conductive metal surface. Read more
Vent Adapter Ring – 3D Printed Solution
A 3D printed adapter ring is a good solution for fitting two different sized plastic pipes together. Design it well and you get a snug fit that should last. Read more
3D Printed Circuit Board Drill Press You Can Make
There are lots of designs for making a circuit board drill press for PCB fabrication. I thought I would try one. Read more
Low Cost Bench Meter Solution for My Workshop
Using a few 3D printed parts, you can re-purpose a portable meter into a low cost bench meter. It’s nice to have the readout at eye level while you are taking measurements. Read more
Using Brass Inserts to attach an LCD Display
This is the first time I have used brass inserts to fasten parts in a 3D printed project. The idea is to use thermal power (heat) to sink these brass inserts into the plastic. This is done with a soldering iron and a steady hand. Read more